Balancing Program Selection - Corghi ProLine Truck 150 Manual De Uso

BALANCING PROGRAM SELECTION

Before starting a balancing operation, the following steps must be followed:
- fit the wheel on the hub using the most suitable flange;
- lock the wheel so that no movement is possible during the wheel spin and braking
phases;
- remove any old counterweights, stones, dirt or other foreign bodies from the wheel;
- set the wheel's geometric data correctly.
At start-up, by default, the machine executes the dynamic program (dyn) which uses clip
weights on both sides.
The various balancing programs (except STATIC) can be recalled in NORMAL mode by
simply selecting the keys [P4] or [P5] that represent the type of
weight according to the rim and professional experience, both for the inner sidewall as
well as for the outer sidewall. If, within a lapse of 1.5 seconds, neither of the two keys is
pressed again, the display returns to its previous status without changing the Type of
active Program.
To view the static imbalance, press [F+P2] + .
The machine will show the static imbalance value on the display as seen in figure 21, and
the LED next to the key lights up.
Fig.21: Static imbalance display enabled. The right display indicates the entity of the
static imbalance
UK
To return to dynamic imbalance display, press [F+P2] + . The LED
next to the key will turn off.
The following balancing programs available are displayed in table T4a:
User manual ProLine Truck 150 101