Teac RW-800 Manual Del Usuario página 74

Ocultar thumbs Ver también para RW-800:
In case of trouble with the unit, please take the trouble to look through this chart and see if
you can solve the problem yourself before you call your dealer or TEAC service center.
No power
e Check the connection to the AC power
supply.
No sound from speakers.
eCheck the connection to the stereo
system.
eNo disc has been loaded. Load a disc.
The sound is noisy.
eThe unit is too close to a TV set or
similar appliances. Install the unit
apart from them, or turn them off.
Remote control doesn't work.
eIf the batteries are exhausted, change
the batteries.
e Use remote control unit within the
range (5m/15ft) and point at the front
panel.
eClear obstacles between the remote
control unit and the main unit.
eIf a fluorescent light is near the unit,
put it off.
Cannot play.
eLoad a disc with label side up.
eIf the disc is dirty, clean the surface of
the disc.
eA blank disc has been loaded. Load a
prerecorded disc.
Cannot stop the shuffle playback.
ePress the PLAY MODE button of the
remote control unit twice to cancel the
shuffle mode.
eUnplug the power cord from the AC
outlet and plug it again.
Sound skips.
e Place the unit on a stable place to
avoid vibration and shock.
eIf the disc is dirty, clean the surface of
the disc.
e Don't use scratched, damaged or
warped discs.
74
Troubleshooting
Recording is not possible.
eA playback-only disc or finalized disc
has been loaded. Use a recordable
disc.
eAn attempt is made to record digital
signal from a source while its digital
copy has been prohibited by SCMS.
Use analog recording.
eThe disc does not have a recordable
area. Use another disc.
eThe recording level is too low. Adjust
the recording level.
eCheck the connected components.
Timer doesn't work.
eSet the clock beforehand.
eIf "Timer Error!" is displayed, check the
disc and timer setting.
If normal operation cannot be recovered,
unplug the power cord from the outlet and
plug it again.
Beware of condensation
When the unit (or a disc) is moved from a
cold to a warm place, or used after a sudden
temperature change, there is a danger of
condensation; vapor in the air could
condense on the internal mechanism,
making correct operation impossible. To
prevent this, or if this occurs, leave the unit
for one or two hours with the power turned
on. Then the unit will stabilize at the
temperature of its surroundings.
ENGLISH
Specifications
Media type
CD-RW and CD-R for Digital audio
(record and playback), CD (playback only)
Frequency converter input sampling
frequency
32kHz~48kHz
Recording sampling frequency
44.1kHz
Frequency response
20Hz~20kHz
(playback:±0.5dB, recording:±1dB)
Signal to noise ratio
More than 97dB(playback)
More than 92dB(recording)
Dynamic range
More than 94dB(playback)
More than 92dB(recording)
Total Harmonic Distortion
Less than 0.004%(playback)
Less than 0.005%(recording)
Wow & flutter
Unmeasurable
Audio Input Sensitivity/Impedance
LINE : -10dBV(316mV)/33kΩ
MIC : -50dBV(3.16mV)/47kΩ
Output Level/Impedance
LINE : -10dBV(316mV)/800Ω
PHONES : -35mW/32Ω
Maximum output level
LINE :+6dBV(2.0V)
Power supply
120/230 V AC, 50/60Hz (General export model)
230 V AC, 50Hz (Europe model)
Power consumption
27 W
Dimensions (W x H x D)
435 x 102 x 312 mm (17-1/8" x 4" x 12-5/16")
Weight (Net)
5.5kg (12lb)
Standard Accessories
Audio signal connection cord x 2
Remote control unit x 1
Batteries(AA,R6,SUM-3) x 2
< Design and specifications are subject to
change without notice.
< The illustrations may differ slightly from
production models.
loading