Idiomas disponibles
Idiomas disponibles
ENGLISH
Cleaning the condenser
Clean the condenser periodically.
!
As the fins of the condenser are very sharp,
always wear protective gloves for the next phases.
Use protective masks and glasses in the presence
of dust.
Whenever the condenser has a deposit of
dust in correspondence with the fins, this can be
removed using a suction device or with a brush
applied, using a vertical movement along the
GB
direction of the fins.
!
No other instruments must be used, which
may deform the fins and therefore the efficiency of
the appliance.
To clean, proceed as follows:
1. Open the door (A) of the appliance.
2. Remove the lower panel (B) from the
technical compartment: to do this, remove
the screw fasteners (C).
3. It is now possible to clean the finned part
of the condenser (D) using suitable tools
and protection devices.
4. After cleaning, close the control panel and
fix it with the screws removed beforehand.
Replacing the fuses
The fuses are in the lower part of the
technical compartment (E). To access these, open
C
B
C
D
E
the control panel using the same method listed for
the access and cleaning of the condenser.
48
A
C
