Stahlwille MANOSKOP 714 Manual De Instrucciones página 87

Menu overview
Taring on switching on
 Place the switched off torque and angle wrench
onto a flat surface.
To tare the torque and angle wrench with a
plug-in tool installed, have this e.g. project over
the edge of the bench.
 Make sure that no forces are acting on the torque
and angle wrench.
 Keep the torque and angle wrench steady
throughout the entire taring process.
 To switch the torque and angle wrench on, press
any button.
The symbol and TARE are shown on the
display. The torque and angle wrench is tared within
a few seconds.
The completed taring process can be recognised by
the symbol (taring process ended) on the
display.
Manual taring
Manual taring is necessary if, for example, a value
which is not zero is shown on the display after
bolting processes.
 Place the switched on torque and angle wrench
onto a flat surface.
To tare the torque and angle wrench with a
plug-in tool installed, have this e.g. project over
the edge of the bench.
 Make sure that no forces are acting on the torque
and angle wrench.
 Keep the torque and angle wrench steady
throughout the entire taring process.
 Press the TARE button for longer than two
seconds.
The symbol and TARE are shown on the
display. The torque and angle wrench is tared within
a few seconds.
The completed taring process can be recognised by
the symbol (taring process ended) on the
display.
Menu overview
The menu language set on delivery is German.
 To change the menu language, proceed as
described from page 41.
All of the torque and angle wrench menus are
explained in this chapter. Due to individual settings
undertaken on the torque and angle wrench by the
administrator, it may occur that not all menus or
menu items are displayed.
Menu structure in direct input
Concrete values for a bolting operation are defined
in direct input.
The following measuring modes can be accessed in
direct input:
 Torque
 Angle
 Torque-angle
 Angle-torque.
The available direct inputs are shown as sequence
plans in the following. The direct input entries are
explained in the tables.
27