Stahlwille MANOSKOP 714 Manual De Instrucciones página 104

Using the torque and angle wrench
ATTENTION
Damage to the torque and angle
wrench possible on overloading.
 Make sure that the torque and angle
wrench is not overloaded.
 Do not drop the torque and angle
wrench.
 Do not expose the torque and angle
wrench to any jolts.
 Only actuate the torque and angle wrench using
the handle.
 Grip the handle centrally.
 Tighten tangentially to the swivelling radius and at
right angles to the bolting axis.
Working in "Click" function mode
 Tighten evenly and, in the final phase, without
interruption until a clear jolt is felt and a click is
heard.
The set target torque or the target angle has been
reached.
44
After clicking, the torque and angle wrench is
immediately ready for use again.
During the bolting process in "Click" function mode,
the following displays and signals are provided
depending on the settings which have been
undertaken:
 The current torque or angle value is displayed.
 If an alert limit has been set in the
CONFIGURATION menu, the current value is
shown in yellow as of reaching the alert limit. The
signal lamps light up yellow.
 If a tolerance range has been set and this has
been reached, the current value is shown in
green. The signal lamps light up green. A short
audible signal is heard.
 When the previously set target torque or target
angle value has been reached, the torque and
angle wrench triggers with a perceptible jolt and
an audible click.
 If the previously set upper target torque or target
angle tolerance range is exceeded, the current
value is shown in red. The signal lamps light up
red. A long audible signal is heard.
Working in "Track" function mode
 Monitor the torque or angle value on the display
during tightening.
 Tighten evenly and, in the final phase, without
interruption until the set or desired target torque or
target angle value can be seen.