Stahlwille MANOSKOP 714 Manual De Instrucciones página 85

Preparing the torque and angle wrench
Installing and removing plug-in tools
Proceed as follows to install plug-in tools:
 Insert the plug-in tool into the recessed square on
the wrench head.
The spring-loaded retaining pin on the plug-in tool's
QuickRelease safely lock is depressed due to the
insertion chamfer.
 Continue pressing the plug-in tool to stop.
 Make sure that the retaining pin engages in the
QuickRelease safety lock's detent hole.
 Check that the plug-in tool is seated securely.
 For controlled, clicking left-hand tightening,
connect the plug-in tool to the torque and angle
wrench rotated by 180°.
WARNING
Risk of injury due to unintentional
adjustment of the switching disk on the
plug-in ratchet.
 Prior to the bolting process, use the
switching disk to set the desired
working direction.
 Do not touch the switching disk
during the bolting process.
 When using a plug-in ratchet, switch this by
turning the switching disk to the desired working
direction.
 Plug the appropriate insert onto the square drive
of the reversible ratchet until it audibly engages.
Proceed as follows to remove plug-in tools:
Plug-in tool installed "as standard"
 Press the green QuickRelease button on the
underside of the wrench head (A).
 Pull the plug-in tool out (B).
25