Idiomas disponibles
Idiomas disponibles
Reacting to malfunction messages
Characteristic
Display message:
Overload
Display message:
Calibration due!
Display message:
Change batteries.
Display message:
Electronic fault E10
Display message:
Electronic fault E11
Display message:
Electronic fault E12
Display message:
Electronic fault E13
Display message:
Electronic fault E14
Replacing batteries
If the segments of the battery symbol light up
yellow, the batteries or the rechargeable batteries in
the torque and angle wrench are no longer full.
However, you may continue working.
When the remaining segments of the battery
symbol light up red, the batteries or the
rechargeable batteries in the torque and angle
wrench are almost spent.
Cause
The torque and angle wrench has
been overloaded.
The set calibration interval has
expired.
The batteries are spent.
Electronic fault
Electronic fault
Electronic fault
Electronic fault
Electronic fault
Remedy
Calibrate the torque and angle
wrench using suitable equipment,
see page 58.
Calibrate the torque and angle
wrench using suitable equipment,
see page 58.
Exchange the spent
batteries/rechargeable batteries for
full ones of the same type.
Send the torque and angle wrench
to the service department.
Send the torque and angle wrench
to the service department.
Send the torque and angle wrench
to the service department.
Send the torque and angle wrench
to the service department.
Send the torque and angle wrench
to the service department.
If the red battery symbol segments are ignored,
the torque and angle wrench switches off after
a short while.
Fastener data stored in the torque and angle
wrench are retained in the event of battery
replacement.
If no rechargeable batteries or batteries are
contained in the torque and angle wrench for
longer than 5 minutes, the time has to be
synchronised with the PC using the installed
software following battery replacement.
Make new batteries or charged rechargeable
batteries ready.
Exchange the rechargeable batteries for charged
ones or insert new batteries as described on
page 23.
57
