Stahlwille MANOSKOP 714 Manual De Instrucciones página 119

Accessories
Accessories
Inserts with square drive
 For all conventional bolt head forms and sizes
Plug-in tools
 QuickRelease plug-in ratchets
 Plug-in ratchets
 Square plug-in tools
 Open-ended plug-in tools
 Ring plug-in tools
 Open ring plug-in tools
 TORX plug-in tools
®
 Bit holder plug-in tools
 Welded-on plug-in tools.
Rechargeable battery
 Li-ion rechargeable battery (art. No. 7195-2)
 Charging cradle (art. No. 7160) for li-ion
rechargeable battery
Calibration and adjustment
 Calibration and adjustment facility perfectControl
 7794-1 (torque)
 7794-2 (torque)
 7794-3 (torque and angle)
 Calibration facility Manutork
 7791
 7792
®
®
Service range
 Downloading of current software and operating
instructions from "www.stahlwille.de"
 Repairs
 Checking and readjustment (including accuracy
guarantee and new factory calibration certificate).
 DakkS calibration certificate (DakkS: Deutsche
Akkreditierungsstelle GmbH) can be supplied
STAHLWILLE is an accredited DakkS laboratory for
the measurement variable of torque. The full
address can be found on the last page of these
operating instructions.
Disposal
Dispose of the torque and angle wrench through a
certified specialist disposal company. Observe and
comply with the applicable regulations. If in doubt,
contact your local or municipal administration.
 Dispose of spent batteries and defective
rechargeable batteries at a collection point.
The torque and angle wrench is manufactured from
steel.
The handle is manufactured from
 polyamide (PA) and
 polybutylene terephthalate (PBT)
The torque and angle wrench also contains
electronic components which have to be disposed
of separately.
WEEE registration No.: DE 70431151
WEEE = Waste Electrical and Electronic Equipment
59