Idiomas disponibles
Idiomas disponibles
Undertaking settings on the PC
Setting the time for automatic shut-off
A time after which the torque and angle wrench
switches off automatically when not in use can be
set.
To set this time, the SENSOMASTER software
must be installed on a PC.
Connect the torque and angle wrench to the PC.
Start the SENSOMASTER software installed on
the PC.
Switch the torque and angle wrench on.
Select the "Settings" tab.
Select the "Parameters" tab.
Enter the desired time for automatic switching off
in the "Auto shut-off" area.
If 0 minutes is input, "Auto shut-off" is
deactivated. The torque and angle wrench has
to be switched off manually.
Click onto the "Save data in torque and angle
wrench" symbol.
The torque and angle wrench settings are updated.
The torque and angle wrench switches off and then
switches on again automatically.
Setting password protection
Access to the configuration menu can be protected
by means of an administrator password.
The administrator password may only be assigned
or changed using the SENSOMASTER software.
No administrator password is set on delivery.
A maximum of four digits are available for the
administrator password. Only numbers may be
used.
42
Connect the torque and angle wrench to the PC.
Start the SENSOMASTER software installed on
the PC.
Switch the torque and angle wrench on.
Select the "Settings" tab.
Select the "Parameters" tab.
Mark the "Password activated" check box in the
"Password protection" area.
Set four numbers for the administrator password.
Click onto the "Save data in torque and angle
wrench" symbol.
The torque and angle wrench settings are updated.
The torque and angle wrench switches off and then
switches on again automatically.
Disconnecting the torque and angle
wrench from the PC
Proceed as follows to disconnect the torque and
angle wrench from the PC after data transfer:
Remove the micro USB connector from the torque
and angle wrench PC connection socket.
Seal the PC connection socket with the cover.
