Fagor PS-50/200 TP2 Manual De Instrucciones página 28

3.3. Programme start and sequence
3.3.1. Running the programme
When START is pressed, the programme starts and all the information about the current
programme is displayed on the screen (running screen).
1
4
Regulation screen
1. Infeed speed and speed control arrows
2. Programmed temperature
3. Accessing the menu when the programme is running (display of input and
output status, real-time statistics and programme backup), see section 3. Access
can be disabled in the configuration menu (screen management - see section 3.4.3)
4. Actual cylinder temperature and temperature setting arrows
5. STOP: Button to stop the machine or switch to cooling phase if the actual
temperature is above 80°C
It is only possible to adjust the speed from a certain temperature (130°C as standard) which
can be modified in the maintenance menu, before this temperature is reached, the speed
adjustment arrows are greyed out. Below is the screen (all options) during the pre-heating
phase (the central icon and the speed adjustment arrows are greyed out).
3.3.2. AUTO and HPS
These two operating modes are standard on the PS-65 TP2 model and optional on the PS-50
TP2 model.
Below are the screens depending on the different activated modes (these operating modes
are activated from the maintenance menu and the machine must be equipped accordingly).
It is possible to operate with or without one of the two options by selecting the required mode
directly by pressing the screen (the option is enabled when the icon is blue) at any time during
execution.
Heating screen
3
2
5
24