Pixsys ATR244-12ABC Manual De Instalación página 53

168 A.3.S.e. Alarm 3 State Error
Alarm 3 output status in case of error.
If the alarm output is relay
Contact or open valve. Default
open
If the alarm output is digital (SSR):
Digital output OFF. Default
off
If the alarm output is 0-10V:
0 V. Default
0 V
If the alarm output is 0-20 mA or 4-20 mA:
0 mA. Default
0 ma
4 mA.
4 ma
169 A.3.Ld. Alarm 3 Led
Defines the status of the led
ON with open contact, DO switched off or AO deactivated.
o.c.
ON with closed contact, DO switched on or AO activated. (Default)
c.c.
170 a.3.de. Alarm 3 Delay
Alarm 3 Delay.
-60:00..60:00 mm:ss (hh:mm if
Negative value: delay when exit alarm status.
Positive value: delay when enter alarm status
171 A.3.S.p. Alarm 3 Setpoint Protection
Allows or not to change the alarm 3 setpoint.
Editable by the user (Default)
FrEE
Protected
Lock
Protected and not visualized
HidE
172 A.3.Lb. Alarm 3 Label
Selects the message displayed in case of alarm 3 intervention.
Disabled. (Default) 0.
disab.
Message 1 (see table on paragraph 14.1) ...
lb. 01
Message 20 (see table on paragraph 14.1)
lb. 20
Custom message (modifiable by the user through the App or via modbus)
user.l.
173÷176 Reserved Parameters - Group I
Reserved parameters - Group I
GROUP J -
AL. 4
177 AL. 4 .f. Alarm 4 Function
Alarm 4 selection.
Disabled (Default)
diSab.
Absolute Upper Activation. Absolute referred to the process, active over
Ab.up .A.
Absolute Lower Activation. Absolute referred to the process, active under
Ab.Lo.a.
Band alarm (command setpoint ± alarm setpoint)
bAnd
Upper Deviation alarm
up .dev .
Lower Deviation alarm
Lo.dev .
Absolute Command Upper Activation. Absolute alarm referred to the command
Ab.c.u.A.
setpoint, active over
Absolute Command Lower Activation. Absolute alarm referred to the command
Ab.c.L.A.
setpoint, active under.
Status alarm (active in RUN/START)
run
Cold actuator auxiliary (Cold action in double loop)
cooL
Probe error. Alarm active in case of sensor rupture.
Prb.er.
A3 in correspondence of the relevant output.
AL.3.F .
- Alarm 4
CLose
on
10 v
20 ma
21.5ma
). Default: 00:00.
=
c. aux
Contact or closed valve.
Digital output ON.
10 V.
20 mA.
21.5 mA.
User manual - ATR244 - 53