Tabla de contenido
7. Remove and discard 2 'O' rings from evaporator
7. Remove and discard 2 'O' rings from evaporator
pipes.
CAUTION: Immediately cap all air conditioning pipes to prevent
ingress of dirt and moisture into the system.
Refit
1. Clean air conditioning pipe connections.
1. Clean air conditioning pipe connections.
2. Lubricate new 'O' rings with refrigerant oil and fit to
2. Lubricate new 'O' rings with refrigerant oil and fit to
air conditioning pipes.
3. Remove caps from new thermostatic expansion
3. Remove caps from new thermostatic expansion
valve and fit to old unit.
4. Engage valve to evaporator pipes.
4. Engage valve to evaporator pipes.
5. Position evaporator pipe bracket, fit and tighten
5. Position evaporator pipe bracket, fit and tighten
Allen bolts to 7 Nm.
6. Engage pipes to valve and position pipe clamp.
6. Engage pipes to valve and position pipe clamp.
7. Tighten pipe clamp bolt to 5 Nm.
7. Tighten pipe clamp bolt to 5 Nm.
8. Renew receiver drier.
8. Renew receiver drier.
+
RECEIVER DRIER, page 82-5.
9. Recharge air conditioning system.
9. Recharge air conditioning system.
+
REFRIGERANT RECOVERY, RECYCLING AND
RECHARGING, page 82-1.
AIR CONDITIONING
CONTROL SWITCH
$% 82.20.07
Remove
1. Remove console closing panel.
1. Remove console closing panel.
+
CONSOLE CLOSING PANEL, page 76-4-8.
2. Release switch from centre console.
2. Release switch from centre console.
3. Disconnect multiplug from switch.
3. Disconnect multiplug from switch.
4. Remove switch.
4. Remove switch.
Refit
1. Connect multiplug to switch and fit switch to centre
1. Connect multiplug to switch and fit switch to centre
console.
2. Fit console closing panel.
2. Fit console closing panel.
+
CONSOLE CLOSING PANEL, page 76-4-8.
82-7
REPAIRS
Tabla de contenido
