Tabla de contenido
7. Align air conditioning pipes to condenser and tighten
7. Align air conditioning pipes to condenser and tighten
bolts to 5 Nm.
8. Renew receiver drier.
8. Renew receiver drier.
+
RECEIVER DRIER, page 82-5.
9. Fit front bumper valance.
9. Fit front bumper valance.
+
BUMPER VALANCE - FRONT, page 76-2-9.
10. Recharge air conditioning system.
10. Recharge air conditioning system.
+
REFRIGERANT RECOVERY, RECYCLING AND
RECHARGING, page 82-1.
AIR CONDITIONING
RECEIVER DRIER
$% 82.17.03
Remove
1. Recover refrigerant from A/C system.
1. Recover refrigerant from A/C system.
+
REFRIGERANT RECOVERY, RECYCLING AND
RECHARGING, page 82-1.
2. Disconnect multiplug from trinary switch.
2. Disconnect multiplug from trinary switch.
3. Loosen and remove trinary switch, remove and
3. Loosen and remove trinary switch, remove and
discard 'O' ring.
4. Remove 2 bolts securing A/C pipes to receiver drier.
4. Remove 2 bolts securing A/C pipes to receiver drier.
5. Remove and discard 2 'O' ring seals from pipes.
5. Remove and discard 2 'O' ring seals from pipes.
CAUTION: Immediately cap all air conditioning pipes to prevent
ingress of dirt and moisture into the system.
6. Loosen 2 Allen screws clamping receiver drier
6. Loosen 2 Allen screws clamping receiver drier
bracket.
7. Position pipes aside and remove receiver drier.
7. Position pipes aside and remove receiver drier.
Refit
1. Clean A/C pipe connections.
1. Clean A/C pipe connections.
2. Lubricate new 'O' ring seals with clean refrigerant oil
2. Lubricate new 'O' ring seals with clean refrigerant oil
and fit to air conditioning pipes.
3. Remove caps from new receiver drier and fit to old
3. Remove caps from new receiver drier and fit to old
unit.
4. Fit receiver drier to bracket and secure bracket
4. Fit receiver drier to bracket and secure bracket
clamp screws.
5. Engage A/C pipes to receiver drier and tighten
5. Engage A/C pipes to receiver drier and tighten
retaining bolts to 5 Nm.
6. Lubricate new trinary switch 'O' ring with clean
6. Lubricate new trinary switch 'O' ring with clean
refrigerant oil and fit 'O' ring to trinary switch.
7. Fit trinary switch and tighten to 10 Nm.
7. Fit trinary switch and tighten to 10 Nm.
8. Connect multiplug.
8. Connect multiplug.
9. Recharge A/C system.
9. Recharge A/C system.
+
REFRIGERANT RECOVERY, RECYCLING AND
RECHARGING, page 82-1.
82-5
REPAIRS
Tabla de contenido
