Tabla de contenido
ENGINE MANAGEMENT SYSTEM - MEMS
SENSOR - MANIFOLD ABSOLUTE
PRESSURE (MAP)
$% 18.30.56
Remove
1. Remove engine cover.
1. Remove engine cover.
+
ENGINE COVER, page 12-27.
2. Disconnect MAP sensor multiplug.
2. Disconnect MAP sensor multiplug.
3. Remove 2 Torx screws securing MAP sensor to inlet
3. Remove 2 Torx screws securing MAP sensor to inlet
manifold.
4. Remove MAP sensor from manifold.
4. Remove MAP sensor from manifold.
Refit
1. Clean MAP sensor and manifold mating faces.
1. Clean MAP sensor and manifold mating faces.
2. Fit MAP sensor to inlet manifold, fit and tighten Torx
2. Fit MAP sensor to inlet manifold, fit and tighten Torx
screws.
3. Connect MAP sensor multiplug.
3. Connect MAP sensor multiplug.
4. Fit engine cover.
4. Fit engine cover.
+
ENGINE COVER, page 12-27.
18-20
REPAIRS
SENSOR - HEATED OXYGEN (HO2S) - PRE CAT
$% 19.22.16
Remove
1. Disconnect battery earth lead.
1. Disconnect battery earth lead.
2. Remove engine cover.
2. Remove engine cover.
+
ENGINE COVER, page 12-27.
3. Rotate HO2S sensor multiplug through 90° to
3. Rotate HO2S sensor multiplug through 90° to
release from mounting.
4. Disconnect HO
4. Disconnect HO
4. Disconnect HO
4. Disconnect HO
S sensor multiplug from harness.
S sensor multiplug from harness.
S sensor multiplug from harness.
S sensor multiplug from harness.
2
2
2
2
5. Raise rear of vehicle.
5. Raise rear of vehicle.
WARNING: Do not work on or under a vehicle
supported only by a jack. Always support the vehicle on
safety stands.
6. Remove HO2S sensor lead from clip.
6. Remove HO2S sensor lead from clip.
7. Using a 22 mm crows foot spanner, remove HO2S
7. Using a 22 mm crows foot spanner, remove HO2S
sensor.
Refit
1. Fit HO2S sensor and tighten to 55 Nm.
1. Fit HO2S sensor and tighten to 55 Nm.
2. Fit HO2S sensor lead to clip.
2. Fit HO2S sensor lead to clip.
3. Connect multiplug and secure to mounting.
3. Connect multiplug and secure to mounting.
4. Fit engine cover.
4. Fit engine cover.
+
ENGINE COVER, page 12-27.
5. Remove stands and lower vehicle.
5. Remove stands and lower vehicle.
6. Connect battery earth lead.
6. Connect battery earth lead.
Tabla de contenido
