Tabla de contenido
HEATING & VENTILATION
14. Remove nut securing heater unit to bulkhead.
14. Remove nut securing heater unit to bulkhead.
15. Remove heater unit.
15. Remove heater unit.
Refit
1. Position heater to mountings.
1. Position heater to mountings.
2. Tighten all fixings to 10 Nm.
2. Tighten all fixings to 10 Nm.
3. Connect multiplug to heater blower.
3. Connect multiplug to heater blower.
4. Connect hoses to heater matrix and secure with
4. Connect hoses to heater matrix and secure with
clips.
5. Position valve and secure with screws.
5. Position valve and secure with screws.
6. Fit screen duct.
6. Fit screen duct.
7. Connect multiplugs to control unit.
7. Connect multiplugs to control unit.
8. Position control cables and connect to control unit.
8. Position control cables and connect to control unit.
9. Align cable outers to control unit and tighten clamp
9. Align cable outers to control unit and tighten clamp
screws.
80-14
REPAIRS
10. Release clip securing cable outer to heater valve.
10. Release clip securing cable outer to heater valve.
11. Turn temperature control to COLD.
11. Turn temperature control to COLD.
12. Push heater control valve to the COLD position and
12. Push heater control valve to the COLD position and
secure cable clip.
13. Refill cooling system.
13. Refill cooling system.
+
DRAIN AND REFILL, page 26-1.
14. Position alarm ECU to heater control, fit and tighten
14. Position alarm ECU to heater control, fit and tighten
nuts to 4 Nm.
15. Fit evaporator.
15. Fit evaporator.
+
EVAPORATOR, page 82-8.
Tabla de contenido
