Tabla de contenido
HEATING & VENTILATION
4. Remove 15 clips and 2 screws securing two halves of
4. Remove 15 clips and 2 screws securing two halves of
casing.
5. Remove foam seal from outlet vent and matrix bleed
5. Remove foam seal from outlet vent and matrix bleed
nipple.
6. Separate two halves of casing.
6. Separate two halves of casing.
7. Remove heater matrix.
7. Remove heater matrix.
Refit
1. Position matrix to heater.
1. Position matrix to heater.
2. Position two halves of casing, ensuring correct
2. Position two halves of casing, ensuring correct
location of flow direction flap.
3. Secure casing halves with clips and screws.
3. Secure casing halves with clips and screws.
4. Clean sealing faces.
4. Clean sealing faces.
5. Fit foam seals to outlet vent and bleed nipple.
5. Fit foam seals to outlet vent and bleed nipple.
6. Engage harness clips and connect multiplugs.
6. Engage harness clips and connect multiplugs.
7. Fit heater.
7. Fit heater.
+
HEATER, page 80-9.
80-18
REPAIRS
Tabla de contenido
