Coltene CanalPro CL Instrucciones Para El Uso página 49

Problem Cause
The battery The power cord plug is not inserted into
charger does the outlet.
not work. (the
The power cord jack is not inserted into
power for the
the inlet on the charger.
charger is not
The power for the charger is OFF.
turned ON)
The fuse has burnt.
The motor If nothing is displayed on the liquid crys-
handpiece set tal panel of the handpiece even when it
to the charger is set to the charger, failure in the circuit
abnormally is predicted.
gets hot.
The motor The contra angle head has jammed up.
handpiece does
not rotate.
Power from the Batteries are weakened (lower remaining
motor hand- battery capacity)
piece is weaker
than usual.
The Auto Re- Batteries are weakened (lower remaining
verse does not battery capacity)
work.
Rotation speed Batteries are weakened (lower
of the motor remaining battery capacity)
handpiece is
lower.
The alarm The ambient temperature is low.
sounds when
There is some residual contamination on
the motor
the rotating shaft of the contra angle
handpiece is
head.
rotated.
Solution
Insert the power cord plug into the outlet.
Insert the power cord jack into the inlet on
the charger.
Turn ON the power for the charger.
Contact your dealer.
Contact your dealer.
Clean or replace the contra angle head.
Charge the batteries.
Charge the batteries.
Charge the batteries.
Use in a warm room.
Clean the contra angle head.
49