Troubleshooting - Coltene CanalPro CL Instrucciones Para El Uso

13. Troubleshooting

When trouble is found, please check the following again before consulting your dealer. If none of these is
applicable or the trouble is not remedied even after action has been taken, a failure of this product is sus-
pected. Contact your dealer.
Problem Cause
The power is Batteries have fully discharged. (Has the
not turned on. handpiece been left with batteries insert-
ed for a long time?)
No batteries are inserted.
The internal fuse has burnt.
The battery Batteries have been completely dis-
charger does charged.
not work. (The
The temperature of batteries is low.
CHARGE anima-
tion does not
display)
The temperature of batteries is high.
The voltage of a battery is too high
The motor handpiece is correctly set to
the charger.
Metal such as wire or safety pin is placed
on the charger.
An error code is displayed.
48
Solution
Recharge the batteries. If battery does not
fully discharge, charge will start. If the bat-
tery fully discharge, change it for new.
Insert batteries.
Contact your dealer.
Replace with new batteries.
If the temperature of batteries is less than
0°C (32°F), the batteries are not rechargea-
ble. Charge the batteries in a warm room.
(Be careful about moisture condensation.)
If the temperature of batteries is more than
40°C, the batteries are not rechargeable.
Charge within the range of working tem-
perature. It is normal that the batteries be-
come a little bit warm right after charging.
If the batteries are hot under normal oper-
ating conditions, not right after charging,
there may be an abnormality. Contact your
dealer.
Check that no battery other than nickel-
hydrogen battery is used.
Correctly set.
Remove metal on the charger.
See 12. Error Code.