Operations; Charging Batteries - Coltene CanalPro CL Instrucciones Para El Uso

NOTICE
The symbol indicating the remaining amount of the batteries indicates a voltage. When load is applied to
the motor handpiece, the symbol indicating the remaining amount of the battery charge appears to be-
come lower.
„ ALARM Symbol
The present alarm symbol is displayed.
: Alarm ON
: Alarm OFF (No display)
NOTICE
Load alarm when the motor rotates and auto reverse sound can be set to ON/OFF.
(Refer to 6 (4) Alarm Sound Volume Control)

5. Operations

(1) Charging Batteries

1. Insert the power cord jack into the inlet at the back of the battery charger. (Fig. 4)
2. Insert the power cord and plug in. Make sure you have the correct model/voltage.
3. Turn on the power switch. At this time, check that the power lamp lights up. (Fig. 5)
4. Insert the motor handpiece into the battery charge. Charging starts with the charge
mark flashing on LCD.
5. When the buzzer sounds and "
Inlet
WARNING
When the buzzer does not sound and the charging animation is not displayed despite batteries being re-
placed with new ones, immediately stop using and contact your dealer. (Refer to Changing Batteries)
CAUTION
- When the power lamp for the charger does not light up, the internal fuse may be faulty. In this case
please contact your dealer.
- Be careful of handling when placing the motor handpiece in to the charger. Do not force the handpiece
into the charger. Otherwise, failure may be occur.
- If the power cord is inserted into the jack or the power switch is pressed with unnecessary force, the cord
or switch may be broken or a short-circuit may occur.
- Never use the battery charger for anything other than the motor handpiece of this product.
- The charging normally takes approx. 90 minutes, but it depends on battery use conditions, battery fresh-
38
" is displayed on the liquid crystal panel, charging is completed.
Power Cord Jack
Fig. 4
Power Lamp
Power Switch
Fig. 5