Preparatory Operations - Coltene CanalPro CL Instrucciones Para El Uso

(3) Mounting and Removing File
Insert file to contra angle head, lightly turn the file until it engages with the latch mechanism. Push it in-
ward to click. File Removal, depress the push-key and pull out the file.
CAUTION
- When attaching and detaching the file, turn off the power beforehand.
- After the file is locked in place, lightly pull out the file to make sure the file is locked.
- Always clean the shank of the file to be installed before use. Allowing dirt to enter the chuck could cause
loss of concentricity and deterioration of chucking force.
- Do not exceed the rotation speed recommended by the file manufacturers.

(4) Preparatory Operations

1. Hold down the POWER key for more than one second to
turn on the power.
2. Keep holding down the PROGRAM key until program
No. suitable for file to be used is displayed.
3. When changing the set value of speed, torque, gear ra-
tio or auto reverse, press the SELECT key, select the set-
ting item and press the UP/DOWN key to change.
NOTICE
The GEAR RATIO key is fast-forwarded, when it is continu-
ously held down.
(5) Operation
If you press the ON/OFF key briefly, the motor handpiece starts. If you re-press the key, it stops. (Alternate
operation)
If you hold down the ON/OFF key for more than one second, the motor handpiece starts while the key is
pressed. If you release the key, it stops. (Intermittent operation)
40
Fig. 7
<Operation Panel>
ON/OFF key
Liquid crystal panel
SELECT key
PROGRAM key
UP key
DOWN key
POWER key
Fig. 8