Fastening The Machine And Drill Stand With An Anchor - Hilti DD 30-W Manual De Instrucciones

5.3.3 Mounting the machine on the drill stand
If vacuum fastening is used, check to ensure that the drill stand is securely fastened to the working
surface before mounting the machine on the drill stand.
1. Unplug the supply cord from the power outlet.
2. Lock the carriage on the drill stand at the maximum distance from the working surface.
The carriage must be locked in the uppermost position. The machine with the water collector
holder can then be mounted on the drill stand without the water collector coming into contact with
the working surface.
3. Open the clamping piece by turning the locking bolt.
4. Fit the drilling machine onto the carriage.
5. Close the clamping piece by turning the locking bolt.
6. Make sure that the drilling machine is correctly fastened to the drill stand.
5.3.4

Fastening the machine and drill stand with an anchor

Fastening the drill stand with an anchor requires use of the DD M12 S accessory set which, among
other items, includes the DD-LR-CLS anchor spindle and the DD-LR-CLN nut.
1. Mark the center of the hole to be drilled with a cross. The lines of the cross should be longer than the
diameter of the water collector.
The water collector has four protruding marks that can be aligned with the cross.
2. Set the Hilti HKD-D M12x50 anchor for fastening the drill stand adapter plate at a distance of 12 cm
from the hole center mark.
When setting the anchor, observe the instructions for use enclosed with the anchor.
3. Mount the machine on the drill stand. → page 36
4. Turn back the two leveling screws until they no longer project.
5. Place the drill stand, with the machine mounted on it, over the clamping spindle and then secure the drill
stand temporarily by screwing on the clamping nut (DD M12 S accessory set).
Tighten the spindle securely only after the core bit has been positioned exactly over the center
point of the hole to be drilled ( → page 37).
6. Level the drill stand by turning the two leveling screws.
5.3.5 Fitting the hand wheel
The hand wheel can be fitted on either side of the drill stand.
1. Fit the hand wheel onto the axle.
2. Flip the ring on the retaining pin into the open position and insert the pin in the hole.
3. Close the ring on the retaining pin.
5.3.6 Fit or exchange the sealing ring.
1. Disconnect the supply cord plug from the power outlet.
2. Fit the sealing ring into the groove in the water collector and push the sealing ring down until it is heard
to engage.
3. To remove the sealing ring, turn it counterclockwise and pull it up out of the water collector.
36 English
Printed: 04.07.2019 | Doc-Nr: PUB / 5283477 / 000 / 06
13
14
10
2048397
*2048397*