Corghi EYE LIGHT Manual De Uso página 65

-
the number of partial spins made since the
last manual reset;
-
the total weight quantity saved by the machine
since its first start-up;
-
the partial weight quantity saved since the
last manual reset;
- two histograms that compare the quantity
of weight required if the "Less Weight" pro-
gramme (red bar) is not used and the
quantity required if the "Less Weight" pro-
gramme (green bar) is used for the
entire service life of the machine for clip and
adhesive weights.
The Reset button
reset the partial spin counters and the weight
quantity saved.
To quit the counter display, press the Exit but-
ton .
If connected to an approved printer, the Print
menu secondary control key
used to start the print procedure for the Less
Weight programme.
2. MANUAL ENTRY OF WHEEL DIMENSIONS
In the event of failure of the internal and/or ex-
ternal laser sensors or incorrect measurement
of one of the three working dimensions, the
geometric data can be entered manually using
the following procedure.
A screen is displayed with the default or previ-
ously measured wheel dimensions.
Using the number pad, one or more of the wheel
EYE LIGHT - Operator's manual
dimensions can be changed.
-
-
-
-
can be used to
can be
-
-
The wheel balancer prepares for manual entry
of the distance.
Using the number pad, change the distance
displayed by entering the distance measured
with a tape measure between the right edge
of the body and the inner edge of the rim
(Fig. 18).
press the button
confirm and then enter the width value
Change the displayed value to the value
measured using the manual calliper (Fig. 19).
press the button
confirm and then enter the diameter value;
Change the value of the diameter displayed
by entering the value indicated on the tyre
18
on the monitor to
UK
19
on the monitor to
65