Error Messages - Corghi EYE LIGHT Manual De Uso

To save the new settings, press the Save
button and press the Exit button
to go back to the main working screen.
5.3. Unbalance sensitivity calibration
This procedure should be performed whenever
calibration appears to be out of the tolerance range
or when the machine requires this procedure to be
performed by displaying the E 1 error message.
Calibrate as follows:
- select the sensitivity calibration icon in the
configuration programme menu;
- Fit a wheel of average dimensions (diameter
no less than 14") and preferably with a small
imbalance only on the wheel balancer.
- perform a spin;
- At the end of the spin, fix the calibration
weight supplied with the machine on the shaft
assembly bell as indicated in figure 20.
- perform a second spin;
- At the end of the spin, change the position of
the calibration weight on the shaft assembly
bell as indicated in figure 21
EYE LIGHT - Operator's manual
- Perform a third spin. This last calibration phase
consists of three consecutive spins executed
automatically.
If the calibration has been successful, a permis-
sion acoustic signal goes off at the end of the
spin; otherwise, the E 2 message is temporarily
displayed.
Notes:
- Once the procedure is finished, remove the
calibration weight.
- Press the key to interrupt the calibration
procedure at any time.
- This calibration is valid for any kind of wheel.
5.4. Service
This programme displays some data that are
used to test machine operation and to detect
the malfunctioning of some devices. Since these
data are not useful for the operator, it is recom-
mended that only technical support technicians
consult them.
20

ERROR MESSAGES

The machine can recognise a certain number
of malfunction conditions and signals them by
displaying the relevant messages.
– A – Notice messages
A 3
wheel not suitable for performing the sensitivity
calibration, use a wheel of average dimensions
(typically 5.5"X14") or larger but with a weight
that does not exceed 40 kg.
21
UK
73