Corghi EYE LIGHT Manual De Uso página 61

a potential danger.
The wheel can be locked in three ways in order
to make the weight application operation easier:
- By keeping the wheel in the centred position
for approximately one second. The brake ac-
tivates automatically with a reduced braking
force so as to allow the operator to move the
wheel manually until the correct position for
the other weight's application is reached.
- By pressing the Stop button
the wheel is in one of the weight application
positions and the brake is not on. The wheel is
unlocked by pressing the same button again,
performing a spin or after 50 seconds.
The shaft locking system can also be useful dur-
ing installation of special centring accessories.
If the Stop button
the wheel is rotating, the spin will be prematurely
interrupted.
In the version with a motorised wheel guard,
pressing the Stop
wheel moving will cause the spin to stop prema-
turely and the wheel guard to open.
If the automatic position search (RPA) function
is active, the machine stops the wheel in the
weight application position on the outer side
at the end of each balancing spin; if it is equal
to zero, the wheel is stopped in the inner side
weight application position.
By selecting the central part of one of the unbal-
ance position indicators, an automatic centred
position search starts.
Balancing programmes for alloy
rims
ALU 1 - 2 - 3 - 4 - 5
These programmes are used for maximum preci-
sion balancing of light alloy rims.
This type of wheel balancer is particularly suit-
able for application of adhesive weights on the
rim, thanks to the forward position of the wheel
in relation to the body, which allows a large zone
on the inside of the rim to be accessed freely.
EYE LIGHT - Operator's manual
To access one of these programmes, select at
least one adhesive weight.
Now proceed as follows:
-
-
-
when
is pressed while
button with the
- If the first section of the rim is correct and only
1. Turn the wheel clockwise or anticlockwise to
2. Select the centre of the plane selected for
Press the Dimensions button
enable automatic dimension measurement.
The button remains pressed and the inner
light turns red
Spin the wheel by lowering the guard.
Wait for the wheel to stop automatically and
the image taken by the telecamera showing
the automatically recognised the first section
of rim to be displayed indicated by a red
segment and a horizontal arrow to the left.
If the automatic selection of the start of the
rim is NOT correct, select the horizontal arrow
and using one of the 4 methods
indicated in the paragraph "dynamic balan-
cing", make the change.
one plane of an adhesive weight needs to be
modified, select the vertical arrow
then memorise the new position remembering
that the laser point indicates the centre of the
adhesive weight using one of the 3 methods
described below:
change the position of the laser point until the
centre of the plane selected for application
of the adhesive weight lights up; then press
the Enter button
sition and then the Exit button
to
.
and
to memorise the po-
.
61
UK