Description Of Machine Functions - Corghi ProLine Truck 150 Manual De Uso

To activate the block, press [P9]
To deactivate the electromagnetic clamping
brake, press [P9]
The block is deactivated automatically in
the following cases:
• Every time a balancing spin is run;
• Every time a RPA procedure is performed
(stop of the wheel on the imbalance
position) at low speed;
• After one minute of continuous activation.
The block can be used manually only in
NORMAL mode. It cannot be used in the
SERVICE mode.
DESCRIPTION
OF MACHINE
FUNCTIONS
NORMAL, SERVICE, STAND-
BY operating modes
The machine features three operating
modes:
• NORMAL mode. This mode is enabled
when the machine is turned on and allows
using the machine to perform wheel
balancing.
• SERVICE mode. In this mode, various
programs are available for performing
settings (such as measurements in grams
or ounces) or checking the machine
operation (such as calibration).
• STAND-BY mode. After 5 minutes without
user activity, the machine automatically
switches to STAND-BY mode to reduce
electrical consumption (both with wheel
guard raised or lowered). The
green LED on the display panel flashes
98
.
again.
Note: The machine will also exit STAND-
BY mode by lowering the wheel guard
or by pressing the [P8] Start
key with wheel guard lowered. In these
cases spinning will also be started up
immediately.
To use the machine, select or set the
following:
• Program Type (program for wheels with
• Wheel Type (car, truck, SUV). Default =
• Size of the wheel to be balanced. The
• Dynamic or Static Balancing. Default =
• Display resolution X1 or X5. Default = X5.
The selections described above can be
entered before or after the spin. For any
variation of the selections or data settings,
the machine will run a recalculation by
displaying the new imbalance value.
when the machine is in this operating
mode. All acquired data and settings
are retained in STAND-BY mode. When
in SERVICE mode, the machine cannot
be switched to STAND-BY mode.
To exit STAND-BY mode, proceed with
one of the following options:
® Press any key (except [P7]
® Turn manually the wheel;
® Remove the Distance and Diameter
sensor from the rest position.
Use of the machine in normal
mode
steel, aluminium or special aluminium
rims). Default = program for wheels with
steel rims;
truck;
measurements can be entered manually
(always) or in partially automatic mode.
Dynamic;
User manual ProLine Truck 150
);