Pressure Time; Machine Function; Machine Disconnection - OEM PRESSFORM 350 Manual De Uso

5.3.b - PRESSURE TIME (Fig 4)
By pressing the push-b utton (1) three times , the LED
(2), which indicates the set pressure time of the dough,
blinks, bef ore the lo wer dish lo wering star ts. Oper ate
the push-button (3) or (4) to change the value.
To store the set data, go out from the modification men u
by pressing the key "SEL" until ON is displayed.
Normally, the time setting shall amount 3 seconds.
WARNING
If you set a time e xceeding 3.5 seconds, a dough
baking could start.
5.3.c - ALARM CONDITIONS DURING THE

MACHINE FUNCTION

During the machine functioning, f ollowing alar m
conditions could occur and in this case the y are
displayed:
AL1 = Hand protection micro switch is not enabled.
Lower the transparent protection before pressing
the lower dish lifting push-button.
AL2-AL3 = Upper or lower micro limit switch trouble.
Contact our technical customer service
AL4 = Dish o vertemperature. It occurs when the dish
temperature exceeds 220 ° C.
Contact our technical customer service
AL5 = Inverted phase.
Invert two of the three phases placed on the cutout
switch being on the upper side of the machine.
5.3.d - MACHINE STOPPING UNDER EMERGENCY
CONDITIONS (Fig 5)
• In EMERGENCY case , press the push-b utton "1" or
release the push-button (2).
5.3.e - MACHINE DISCONNECTION (Fig. 5)
To disconnect the machine y ou shall position the light
switch (1) on "0"; the switch lamp goes out. Disable the
switch on the upper machine side.
GB - 18
IMPORTANT
FIG. 4
1 3
FIG. 5
1
PIZZAFORM
Functioning
4
2
2