Electrical Connection - OEM PRESSFORM 350 Manual De Uso

PIZZAFORM
Installation and connections
3.2.b - POSITIONING ON TRAILER-MOUNTED
SUPPORT (Fig. 3)
It is possible to place the machine on an appropriate
trailer – mounted support available on option, to position
the machine proceed as follows:
• Lock the wheels (1) of the trailer – mounted support
(2).
• Hoist the machine as shown in paragraph 3.1. and
locate it on the support (2).
• Remove the drawer (3) and the back (5) to easily reach
the lower supporting surface part.
• Fasten the machine to the support with the screws (4)
provided.

3.3 - ELECTRICAL CONNECTION

DANGER
• The power feed line should be provided with a
suitable omnipolar DISCONNECTING SWITCH
(automatic thermomagnetic switch or differential)
placed before the control unit main switch, with
a minimum contact opening of 3 mm.
• The earthing system should comply with the local
electric regulations in force.
• The electric power cables should comply with
the maximum current required by the machine,
so that the total voltage drop at full charge will
be less than 2%.
• The specifications of the electric power line
should correspond to the specifi cations of the
identifi cation plate and to those mentioned in
the technical specifi cations table that can be
consulted in the fi rst part of this booklet.
DANGER
Before connecting the machine with the electric
line, make sure that the DISCONNECTING SWITCH
is disconnected (line not energized), therefore:
• Connect the power cable (1) of the machine with the
disconnecting switch placed above.
FIG. 3
3
1
4
FIG. 3
3
2
1
1
4
5
GB - 11