Stahlwille Manoskop 730D Serie Instrucciones De Servicio página 43

EN
Short instructions -
practical example
An example of setting the 730D/20 torque wrench
completely is described in the following. The following
data are to be set:

Torque value 90 N·m

"Cut-out" function mode

Bolting tolerance –3 N·m, +5 N·m

The values which are achieved are to be saved.

Bolting application number 1000.

The extension is 40 mm.

Place the torque wrench on a flat surface.

Make sure that no forces are acting on the torque
wrench.

Press any button to switch on the torque wrench.
The software version number is shown in the display.

Press the OK button.
If the "Save values" function is switched on, the four-
digit bolting application number is displayed.

To confirm the bolting application, press the OK
button.
The current torque value which is set is displayed.
The "TARA!" symbol flashes in the display. The torque
wrench is automatically tared within a few seconds.

To set the torque value, press the F button until the
torque value is displayed.
The set torque value flashes.

Use the arrow buttons to set the torque value to 
90 N·m.

Press the F button.

Use the arrow buttons to set the unit of measure-
ment to N·m, if necessary.
Attentio n
Material damage possible due to
incorrectly set values.

Make sure that the torque value which is set after
changing the unit of measurement is correct.

Press the F button.

Select "On" to set the "Cut-out" function mode.

Press the F button.

To work with a bolting tolerance, use the arrow
buttons to select "On".

Press the F button.

Use the arrow buttons to set the lower tolerance
range.

Press the F button.

Use the arrow buttons to set the upper tolerance
range.

Press the F button.

In order to save the bolting data, use the arrow
buttons to select "On".

Press the F button.
The first digit of the four-digit bolting application
number flashes.

Use the arrow buttons to select the first digit.

Press the F button.

The second digit of the four-digit bolting application
number flashes.
17