Stahlwille Manoskop 730D Serie Instrucciones De Servicio página 40

EN
Setting the function mode
"Cut-out" or "Indicating" function mode can be set.

Press the F button until the "Click" symbol is
displayed.
"On" or "OFF" flashes.

Use the arrow buttons to select the desired
function mode.

Select "On" to set the "Cut-out" function mode.

The "Cut out" function mode can be recognized
by the "Click" symbol in the display.

Select "OFF" to set the "Indicating" function mode.
The "Click" symbol is not displayed.

Save the setting as described on page 13.
Setting the bolting tolerance
This function can be used to set the upper and lower
tolerance value for the set torque value.

Press the F button until the "Tol±" symbol is
displayed.
"On" or "OFF" flashes.

To work without a bolting tolerance, use the arrow
buttons to select "OFF".

To work with a bolting tolerance, use the arrow
buttons to select "On".

Press the F button.

Use the arrow buttons to set the desired lower
tolerance value.

The lower tolerance value is identified with a
minus symbol.

Press the F button.

Use the arrow buttons to set the desired upper
tolerance value.

A bolting tolerance which has been set can be
recognized by the "Tol±" symbol in the display.

Save the setting as described on page 13.
Saving values
This function can be used to determine whether or not
the bolting data are saved. This is carried out
automatically in the "Cut-out" function mode. In the
"Indicating" function mode, press the OK button twice.
14
If you would like to assign the saved data to the current
time, update the wrench time using the documentation
software.
If you switch on the "Save values" function, you may
also assign bolting application numbers.

Press the F button until the "Disk" symbol is
displayed.
"On" or "OFF" flashes.

To save the bolting data, use the arrow buttons to
select "On".

Ths "Disk" symbol in the display shows whether
the bolting data are saved.

In order not to save the bolting data, use the arrow
buttons to select "OFF".
The "Disk" symbol is not displayed.

Save the setting as described on page 13.
To assign the bolting applications during evaluation
with the PC, bolting application numbers can be
assigned.

The "Save values" function must be switched
on to create a bolting application.

Press the F button until the four-digit bolting appli-
cation number is displayed.

Press the OK button to confirm the number of the
bolting application.

To assign a new number for the bolting application,
press the F button.
The first digit of the four-digit bolting application
number flashes.

Use the arrow buttons to select the first digit.

Press the F button.
The second digit of the four-digit bolting application
number flashes.

Proceed as described above to set the remaining
digits for the bolting application number.

Now carry out all of the other menu settings for this
bolting application.

The settings for the current bolting application
are saved in the torque wrench.