Changing The Presser Foot - Texi Black&White Manual De Usuario

EN
When bobbin thread appears on top
side of fabric:
Turn the tension dial to a lower
number to loosen the
upper thread tension.
Thread tension for zigzag stitches:
To sew zigzag stitches, the thread tension should be set to a slightly weaker tension
than when sewing straight stitches. You willobtain a nicer stitch when upper thread
appears on bottom side of fabric.

CHANGING THE PRESSER FOOT

The presser foot must be changed according to the sewing job or stitch you sew.
CAUTION: Turn OFF the power switch before you change the presser foot.
•
Turn the handwheel toward you until the needle is at its highest position.
•
Raise the presser foot (1)
•
Remove the presser foot by pushing the presser foot release lever toward you (2).
•
Place desired foot with its pin directly under the slot (3).
•
Lower the presser foot lifter and the presser foot will snap into place.
92
Texi Black&White INSTRUKCJA 2018.indb 92
When upper thread appears on the
bottom side of fabric:
Turn the tension dial to a higher
number to tighten the upper thread
tension.
Texi Black&White
11.04.2018 16:28