Threading The Upper Thread; Important - Texi Black&White Manual De Usuario

EN

THREADING THE UPPER THREAD

Note : Improper threading sequence , or the wrong
thread running can cause thread tearing, passing stitches,
wrinkling the material.
1.
Raise take-up lever to its highest position by turning
hand wheel toward you.
2.
Raise presser foot.
3. Guide the thread through thread guide (1)
4. Pull the thread into the tension discs (2) (which are
located inside the machine). Then guide the thread to
the bottom of the groove and do a U-turn around the
inside of the tab (3).
5.
Pass the thread through the thread take-up (4) from
right to left.
6. Pull the thread into the inside of the take-up lever until it reaches the eye of the
lever and guide the thread into the thread guide (5)
7. Thread needle eye from front to back (6) and pull thread out under the presser
foot about 10 cm, or use automatic threader.

IMPORTANT:

To verify that the machine is threaded properly in the tension discs, do this simple
check:
1. With the presser foot raised, pull the thread towards the back of the machine.
You should detect only a slight resistance and little or no deflection of the
needle.
2. Now lower the presser foot and again pull the thread towards the back of the
machine. This time you should detect a considerable amount of resistance and
much more deflection of the needle. If you do not detect the resistance you
have miss-threaded the machine and need to re-thread it.
88
Texi Black&White INSTRUKCJA 2018.indb 88
Texi Black&White
11.04.2018 16:28