Converting To Free-Arm Machine; Accessory Case; Changing The Presser Foot - Texi Joy 13 Manual De Usuario

EN

CONVERTING TO FREE-ARM MACHINE

Your machine can be used
either as a flat-bed, or as a free-
arm model. With the extension
table in position, it provides a
working surface as a standard
flat-bed model. Be removing the
extension table (just pull it off to
the left as shown), the machine
converts into a free-arm model.

ACCESSORY CASE

Sewing accessories are stored in inside sewing table
(please refer to the drawing).

CHANGING THE PRESSER FOOT

The presser foot must be changed according to the sewing job or stitch you sew.
CAUTION: Turn OFF the power switch before you change the presser foot.
•
Turn the handwheel toward you until the needle is at its highest position.
•
Raise the presser foot.
•
Remove the presser foot by pushing the presser foot release lever toward you.
•
Place desired foot with its pin directly under the slot.
•
Lower the presser foot lifter and the presser foot will snap Into place.
60
Texi Joy 13 instrukcja 2017.indd 60
Texi Joy 13
16/01/17 19:22