Connecting The Machine; Foot Control; Converting To Free-Arm Machine - Texi Black&White Manual De Usuario

EN

CONNECTING THE MACHINE

Place the machine on a stable table. Be sure
to wipe off any surplus oil from needle plate
area before using your machine the first time.
Make sure that the sewing machine is turned
off (the power switch is set to "O". Before
connecting the power cord, make sure that
the voltage and frequency indicated on the
machine is the same as in your power source.
1.
Connect the power cord to the machine
by inserting the 2-hole plug into the plug
socket
2. Connect the power cord plug to the electric outlet.
3. Turn „ON" the power switch.
4. A LED lamp will light up when switch is turned on.
5. To disconnect, turn the power switch to the „OFF" position, then remove plug
from outlet.
DANGER: Never leave the machine
unattended when plugged in. Always
unplug this machine from the electric
outlet immediately after using and before
maintenance. WARNING: Do not unplug by
pulling on the cord. To unplug, grasp the
plug, not the cord. When foot control is disconnected, the machine will not operate.

FOOT CONTROL

Sewing speed can be varied by the foot control.
The harder you press on the control,
the faster the machine runs.

CONVERTING TO FREE-ARM MACHINE

Your machine can be used either as a flat-bed, or as a
free-arm model. With the extension table in position,
it provides a working surface as a standard flat-bed
model. By removing the extension table (just pull it
off to the left as shown), the machine converts into a
free-arm model.
84
Texi Black&White INSTRUKCJA 2018.indb 84
Power/ light switch "OFF" Power/ light switch "ON"
Texi Black&White
power/light switch
Machine socket
Foot control
11.04.2018 16:27