Opening The Accessory Case; Changing The Presser Foot; Removing The Presser Foot Holder - Texi Tutu MC 9900 Manual De Operación

TEXI Tutu operation manual
ACCESSORIES
Some accessories are provided in the accessory case.
1. Needle set
2. Bobbins
3. Spool pin cap (large)
4. Spool pin cap (small)
5. Straight stitch foot
6. Needle plate screwdriver
7. Screwdriver
8. Buttonhole opener with brush
9. Oiler
10. Buttonhole foot
11. Overcasting foot
12. Zipper foot
13. Blin hem foot

OPENING THE ACCESSORY CASE

To open the accessory case, lift up on the top left side of the table
and pull toward you.

CHANGING THE PRESSER FOOT

The presser foot must be changed according to the stitch you sew, or work you do.
CAUTION: Turn off the power switch before you change the presser foot.
1. Turn the hand wheel toward you until the needle is at its highest point.
2. Raise the presser foot lifter.
3. Remove the presser foot by pushing the presser foot release lever
toward you.
4. Place desired foot with its pin directly under the slot in presser foot
holder.
5. Lower the presser foot lifter and the presser foot will snap into place.

REMOVING THE PRESSER FOOT HOLDER

You may need to remove the presser foot holder to use some
presser feet.
To remove, raise the presser foot lifter and loosen the presser foot
thumb screw (A).
To attach, tighten the screw after raising the presser foot holder.
123