Cutter Deck Adjustments - Jacobsen CV Serie Manual De Seguridad Y Operacion

CUTTER DECK ADJUSTMENTS

GB
The cutting height is determined by the position of the blades in relation to the caster wheels. Changes to
this height are made at (4) points and can be made in any order. Make adjustment selections for each deck
from the height of cut chart for that deck included in this section.
NOTES
– Cutting height must be set the same for all three decks.
– The actual height may vary slightly from the chart value because of tire pressure or condition.
HEIGHT OF CUT (CENTER DECK)
1. Remove the quick pin Q from the top of the
caster wheel pivot spindle
2. Remove the caster wheel from caster support M.
3. Select either Position 1 or Position 2 for wheel
mounting bracket. To change, remove (4)
mounting bolts R, move to the alternate location
and bolt in place.
4. Place the selected size and number of spacers
B
A
1 - 2
1
2
S
CENTER DECK HEIGHT OF CUT CHART
SAFETY & OPERATION MANUAL
below the caster support. Both A-size (6.5 mm)
and B-size (12.5 mm) spacers are provided.
Place the remaining spacers above the caster
support.
5. Replace the quick pin.
6. Place pin P into the proper hole of bracket for
the selected height of cut.
S H K
JACOBSEN HR9510
K
H
GB-25