Jacobsen CV Serie Manual De Seguridad Y Operacion página 15

ASSEMBLY AND SETUP
GB
7. Install one end of the other 5/8 I.D. hose O to
the return port on the tractor frame (right side
when standing in front of tractor) and the other
end to the cutter deck motor port P.
o
8. Connect the 90 fitting end of the smaller 3/8 I.D.
hose N to the drain port M of the cutter deck
motor.
9. Make sure that the hoses do not rub on the
tractor when the deck is raised and lowered.
ASSEMBLY OF WING DECKS TO TRACTOR
1. Start tractor and use implement lift to lower
wing arms
2. Insert bolt A into ball joint on arm B, align the
cutter deck and when in position, insert the
bolt into the mounting nut on the deck and
torque to 168 ft-lb.
3. Insert bolt C into ball joint on arm D, align the
cutter deck and when in position, insert the
bolt into the mounting nut on the deck. (It may
be necessary to adjust the spring tension bolt
E to align the balljoint with the cutter deck.)
Torque bolt to 168 ft-lb.]
JACOBSEN HR9510
SAFETY & OPERATION MANUAL
GB-13