Controls - Jacobsen CV Serie Manual De Seguridad Y Operacion

CONTROLS

GB
L B
2-WHEEL/4-WHEEL DRIVE SWITCH (F)
Push upper half of switch down to enter 2-wheel
drive mode for increased ground speed in trans-
port. This will stop all PTO's and prohibit their use.
Push lower half of switch down to enter 4-wheel
drive mode for increased traction. The tractor must
be in this mode before PTO's can be enabled.
HEADLIGHT SWITCH (G)
(Optional equipment)-Push switch half way for
running lights. Push down fully for headlights
HAZARD LIGHTS SWITCH (I)
(Optional equipment)- Push down for flashing
hazard lights.
TURN SIGNAL LIGHTS SWITCH (H)
(Optional equipment)-rotate switch handle counter-
clockwise for L.H. turn and clockwise for a R.H.
turn.
PTO SWITCH (N)
To commence cutting ensure the decks have been
lowered Push bottom of the rocker switch (A) and
depress foot switch. Push top of rocker switch to
stop cutter unit rotation. (Cutting units stop
rotating automatically when raised.)
GB-18
C
D
E
A
F
N
SAFETY & OPERATION MANUAL
STEERING WHEEL TILT CONTROL (J)
Loosen knob and move steering wheel to desired
position. Retighten knob.
A
THROTTLE CONTROL (B)
Push lever forward to increase engine speed. Pull
back to reduce engine speed.
IGNITION SWITCH (A)
The ignition key should be inserted and turned all
the way clockwise to start engine. Let go of the
key when engine starts. Return key to center to
turn engine off. Turning the key counterclockwise
operates the glow plug to preheat the glow plug
chamber prior to starting. Hold until illuminated
indicator lamp turns off (20-30 seconds) for pre-
heat.
JACOBSEN HR9510
B