Messages - Beissbarth BAC 4100a Instrucciones Originales

Display
AIR FLOW ERROR
CHARGE IN PROGRESS
AIR PURGE
CHECK OIL BOTTLE
ISV CONDITION
PRESSURE TOO HIGH
REFRIGERANT INSUFF.
VACUUM DECAY TEST
FAILED
BAC 4100a Rev. A
Troubleshooting Messages
Cause
Fan is not working. Air flow is
blocked.
Non-condensable gas is
present in ISV that could
contaminate A/C system.
1) After selecting INJECT OIL,
oil inject bottle is not in correct
position.
2) After selecting INJECT OIL,
there is an insufficient amount
of new oil in oil inject bottle
Machine is circulating
refrigerant to build ISV pressure
for a charge cycle.
Excessive pressure has been
detected.
After selecting CHARGE and
entering a desired weight, if the
weight entered will leave less
than .91 kg (2 lbs.) of refrigerant
in ISV after charge, charge
function will not start.
A leak in the vehicle A/C
system.
Solution
Exit current test and contact an
Beissbarth authorized service
center for repair.
Before it charges, the machine
purges air out of the ISV.
1) Verify the oil inject bottle is
attached to the machine as
explained in the Setup section.
2) Fill the oil inject bottle with
new oil as explained in the
Setup section.
The charge process is
automatically interrupted and
the machine operates in a
mode to build tank pressure.
Once tank pressure is sufficient,
the machine automatically
completes the charge.
Press ESC. Refer to Recover
section and recover refrigerant
before proceeding.
Refer to Manually Fill the
Internal Storage Vessel (ISV) in
the Maintenance section.
Exit current test and perform
repairs on the vehicle A/C
system.
35