Setup; Unpack The Machine; Unpack The Accessory Kit; Assemble The Uv Dye Bottle And Two Oil Inject Bottles - Beissbarth BAC 4100a Instrucciones Originales

Setup

Unpack the Machine

1. Remove the bandings from the box.
2. Remove the top carton infold, the molded pulp tray,
and the angle boards.
3. Remove the sleeve from the bottom carton infold.
4. Gently roll the unit forward and off the pallet, avoiding
any sudden shocks to the machine.

Unpack the Accessory Kit

Unpack the accessory kit from the box, and remove the
plastic packaging. The kit consists of
• Calibration weight (533 g).
• Four bottles—oil drain bottle, oil inject bottle 1, oil
inject bottle 2, UV dye inject bottle 3 .
• Plastic pouch containing a warranty card (to be
completed and mailed), applicable MSDS sheets, and
a service center listing.
• Oil drain scale calibration bracket.
Assemble the UV Dye Inject Bottle and
Two Oil Inject Bottles
Follow these instructions to install each oil
inject bottle, as well as the UV dye inject
bottle. Refer to Figure 1.
1. Unthread the cover from the reservoir and
remove the piston.
2. Fill the reservoir only to the MAX FILL line.
Overfilling the reservoir may cause air to be injected
into the vehicle system.
3. Spread a thin film of oil/dye on the piston o-ring (to
reduce seal drag), and insert the piston into the
reservoir. Thread the lid onto the reservoir.
4. Slowly push the piston into the reservoir until you
see oil/dye at the connector.
5. Inspect the bottle to ensure there are no air bubbles
between the piston and the liquid—the piston should
be in direct contact with the liquid.
6. Hold the assembly by the plastic bottle, and insert
the connector into the magnetic coupler on the
machine.
10
WARNING: To prevent personal
injury while working with refrigerant,
read and follow the instructions
and warnings in this manual, and
wear protective equipment such as
goggles and gloves.
Oil Inject
Bottle 1
(white cover)
Oil Inject
Bottle 2
(green color
on cover)
UV Dye
Inject Bottle
(yellow color
on cover)
Figure 1
CAUTION: To avoid chemical
incompatibilities with the internal
components of the machine, use only UV
dyes and oils approved by the vehicle
manufacturer. Problems resulting from
the use of non-approved UV dyes and
oils will cancel the warranty.
Magnetic Couplers