Install The Oil Drain Bottle; Power Up The Machine; Language Selection; Units Of Measure - Beissbarth BAC 4100a Instrucciones Originales

Install the Oil Drain Bottle

1. Hold the oil drain bottle straight, and insert the
connector into the hole until it snaps into place.
Refer to Figure 2 for the location of the oil drain
bottle.

Power Up the Machine

1. Unwind the power cord from the handle, and plug it
into a correct voltage, grounded outlet.
2. Position the machine so the plug and the main
power switch are of easy access for the operator.
Verify the fan vents on the rear of the machine are
not obstructed.
3. Lock the front wheels.
4. Turn the Lockout / Tag Out lever clockwise (CW) to
switch it ON.
5. Turn ON the main power switch.
The first time the machine is powered up, it displays
the license agreement for your approval and then
launches into the initial Setup mode.

Language Selection

The operator selects the language for the screen
prompt displays. English is the default language.
1. Use the UP or DOWN arrow key to toggle through the
available languages.
2 . Press OK to set the selected language.
Unit of Measure
The operator sets the display for units of measure.
Metric is the default.
1. Use the UP or DOWN arrow key to toggle kilograms
or pounds.
2 . Press OK to choose the displayed unit of measure.
BAC 4100a Rev. A
Oil Drain
Bottle
Figure 2
CAUTION: The machine is
programmed to run the setup
procedure as outlined here. To prevent
personal injury, do NOT operate the
machine without the oil fill port plug
installed, because the vacuum pump is
pressurized during normal operation.
Setup
11