Charge; Automatic - Beissbarth BAC 4100a Instrucciones Originales

Operating Instructions — Automatic
Automatic continued
9. The machine displays a summary of actions
performed during the automatic sequence.
Information About the Automatic Function
• The CHARGE function for vehicles equipped
with a single-service fitting should be carried out
manually according to procedures in the vehicle
manufacturer's service manual.
• The amount of oil recovered during RECOVER is
automatically injected before the CHARGE cycle.
The user may choose to have extra oil injected.
• CHARGE mode after injecting oil allows only a high-
side charge.
• If RECOVER was not performed, the amount of oil
to be injected may be entered while programming
the CHARGE information.
• If problems are encountered during the automatic
sequence, the machine "beeps" three times, the
red lights on the front of the machine blink, and
the control panel readout pinpoints the problem
encountered. The sequence remains paused until
the user enters a decision regarding how to proceed.
BAC 4100a Rev. A
21