Beissbarth BAC 4100a Instrucciones Originales página 30

Maintenance
Filter Change continued
3. Hang the shroud on the back of the machine as
shown in Figure 15.
4. Remove the filter by turning it counterclockwise (as
viewed from the bottom of the filter).
5. Refer to Figure 16 while examining the new filter.
Verify both o-rings are lubricated, correctly located
in the grooves as shown, and not damaged. (The
o-rings have been lubricated with ISO6743-3 DVA /
DVC oil.)
6. Install the new filter by threading it clockwise into
place. Verify the filter is positioned correctly as
shown in Figure 17. Tighten the filter to 20 N•m.
7. Recycle the filter that was removed from the
machine according to the laws in your jurisdiction.
28
Figure 15
Filter
O-rings
Figure 16
Assembled
Correctly
Figure 17
Hang
Shroud
Here
Assembled
Incorrectly