Wheel Spin And Automatic Dimension Measurement - Corghi EM9980 Manual De Uso

Centring with flanges
C hub removal
Keep the Stop button
-
keypad pressed for at least 3 seconds to
lock the wheel-holder shaft and the internal
devices.
- Insert the C special key provided with the
machine in the C hub hole (Fig. 12).
- Unscrew the C hub completely.
- Mount the flange on the shaft and lock it with the
two screws (A, Fig. 13) using the CH 6 wrench.
A
- Lock the wheel onto the flange as usual.
IMPORTANT
To work without the hub removed previously the
machine must be set in flange mode as described
in the "CONFIGURATION PROGRAMMES"
section.
EM9980 - Operator's manual
C hub mounting
Proceed as follows to remount the C hub:
- Go to the utility and configuration programmes
on the
and press the
wheel-holder shaft and the internal devices.
- Screw the C hub manually until it reaches the
end position.
- Tighten the C hub by inserting the C special
wrench into the C hub hole (Fig. 14).
12
WHEEL SPIN AND
AUTOMATIC DIMENSION
MEASUREMENT
Wheel spin takes place automatically by lowering
the guard or pressing the Start button
with the guard lowered.
During the spin, the balancer, using the front and
rear laser sensors, will process the rim dimensions
using a special software for the final unbalance
calculation.
13
At the end of the spin, the rated dimensions of
the wheel are displayed in the feedback window,
specifically:
- The nominal rim width (only for dyn, sta, alu3,
alu4 and alu5 programs).
- The nominal rim diameter.
- The distance from the body to the inner edge
of the rim.
Note: at the end of the spin, if the automatic
position search function is enabled, the wheel
may spin with the guard raised.
icon to block the
14
UK
55