Wheel Spin Counter; Wheel Spin; Selection Of Adhesive Weights Application Position - Corghi EM 9550 Plus Manual De Uso

WHEEL SPIN COUNTER

Perform the following procedure to display the
number of wheel spins performed:
- Press the
gramme menu.
- Use the
cursor.
- Select the
- Press the
number of wheel spins performed by the machine
since its first start-up.
- Press the
number of wheel spins performed since the last
machine switch-on (it is reset to zero every
time the machine is switched off).
- Press the
ber of wheel spins performed since the last
sensitivity calibration (it is reset to zero every
time a calibration procedure is performed).
- Press the

WHEEL SPIN

Wheel spins take place automatically by lower-
ing the guard or pressing the
with the guard lowered.
A special safety device stops rotation if the guard
is raised during the spin; in this case, the "A Cr"
message is displayed.
During position search, the wheel can rotate with
the guard raised.
WARNING
Do not operate the machine without the guard
and/or if the safety device has been tampered
with.
58
button to access the pro-
buttons to move the
programme icon.
button to display the total
button to display the partial
button to display the num-
button to exit.
button
EM 9550 Plus - EM 9550 C Plus - Operator's manual
WARNING
Never raise the guard before the wheel has
come to a stop.
WARNING
If the wheel keeps spinning permanently due to
a fault on the machine, switch off the machine
using the main switch or disconnect the plug
from the power supply board (emergency stop)
and wait until the wheel stops before raising
the guard.
SELECTION OF ADHESIVE
WEIGHTS APPLICATION
POSITION
The machine makes it possible for the operator
to select where the adhesive weight should be
applied based on his needs.
To select this configuration, proceed as described
below:
- Press the
gramme menu
- use the
cursor
- Select the FN programme icon
- The message ALU will appear on the left display,
whereas the message LAS will appear on the
right display that indicates the selection of the
adhesive weight application enabled on the
machine;
- press the button to change the machine
configuration; this configuration can be changed
in H12 or CLP.
- press to confirm the selection made
and exit the function.
- To apply the balancing weights refer to the
following table:
button to access the pro-
buttons to move the