Corghi EM9980 Manual De Uso página 67

OPT 6
Now, the real unbalance values of the wheel as it
is mounted on the wheel balancer are displayed.
- Place the wheel in the position indicated on
the screen. If the RPA function is enabled, the
wheel is automatically placed in position.
- The unbalances and percentual improvement
which can be obtained if the user decides to
continue the optimisation procedure appear
in the window.
If the improvement is considered insufficient,
press the Exit button
- Make a double mark of the tyre in 12 o'clock
on the outer side position if direction in
which the tyre is fitted on the rim is not
pointed out, on the inner side position if the
direction is pointed out. If you do not wish
to invert the direction, press the Enable/
disable tyre inversion button
- press the
button on the monitor to confirm the operation
OPT 7
- Remove the wheel from the wheel balan-cer.
- Rotate the tyre (inverting if necessary) on the
rim until the double chalk mark lines up with
the valve.
- Remount the wheel on the wheel balancer.
- press the
button on the monitor to confirm the operation
- Perform a spin by lowering the guard.
When the spin is over the optimisation pro-
gramme has been completed and the weights to
be applied to balance the wheel are displayed.
Special cases
- If an error is made that affects the final result,
the machine signals this with an E 6 message.
- A different working environment can be re-
called between one phase of the programme
and another by pressing the Temporary exit
button
data. When returning to the optimisation
EM9980 - Operator's manual
.
button or the
button or the
without losing the saved
environment, the programme starts up again
from the point where it was interrupted.
- You can quit the optimisation procedure at any
time by simply pressing the Exit
button.
5. AUTOMATIC CLAMPING SYSTEM HUB
REMOVAL/ASSEMBLY MODE
By selecting this setting, the machine is set up for
removing and assembling the automatic clamping
system hub as described in the "USING THE AU-
TOMATIC WHEEL CLAMPING SYSTEM" section.
The message A 52 will be shown on the display
during this setting. This mode lasts 30 seconds,
but the operator can stop it at any moment by
pressing the STOP button.
6. CONFIGURATION PROGRAMMES
The Configuration programmes are those func-
.
tions that are intended for customising the
machine's operation and are normally executed
when the machine is installed.
Select the Configuration programme icon,
to access the following programmes:
6.1
customisation;
6.2
wheel balancer parameter configuration;
6.3
sensitivity calibration;
6.4
service.
UK
67