Scan Mode; Dsview 3 Device Ip Addresses - Fujitsu Control 4 Serie Guia Del Usuario

3. Local and Remote Configuration
To configure modem settings:
1. From the side navigation bar, select Unit View > Appliance > Appliance
Settings > Ports > Modem to open the Appliance Modem Settings screen.
2. Either enable or disable the Modem sessions can preempt digital sessions
check box.
3. Select an Authentication Timeout time from 30 to 300 seconds, and an
Inactivity Timeout time from 1 to 60 minutes.
4. Select Save.
3.10

Scan mode

In Scan mode, the switch automatically scans from port to port (target device to
target device). You can scan multiple target devices, specifying which devices to
scan. The scanning order is determined by placement of the target device in the
list. You can also configure the amount of time before the scan moves to the next
target device in the sequence.
The Scan button is disabled if you are connected via modem.
To add target devices to the Scan list:
1. From the side navigation bar, select Unit View > Target Devices to open the
Target Devices screen.
2. Select the check boxes next to the names of the target devices you wish to
scan.
3. Click Scan.
To configure Scan Time:
1. From the side navigation bar, select Unit View > Appliance > Appliance
Settings > Ports > Local Port UI to open the Local Port UI Settings screen.
2. Under the Scan Mode heading, enter an amount of time in seconds (from 3-
255) in the Scan Time field.
3. Click Save.
3.11

DSView 3 device IP addresses

You can contact and register an unmanaged switch with a DSView 3 server by
specifying the IP addresses of up to four DSView 3 servers.
34
590-1058-640A