Kvm S4 Switch Tools - Fujitsu Control 4 Serie Guia Del Usuario

2. Select the Disconnect Active Session check box.
3.4 KVM s4 Switch Tools
From the Unit Overview screen, you can view the appliance name and type. You
can also perform basic appliance tasks.
Rebooting the switch
To reboot the switch:
1. From the side navigation bar, select Unit View > Appliance > Overview to
open the Unit Overview screen.
2. Click Reboot.
3. A dialog box appears, warning you that all active sessions will be
disconnected. Click OK.
If you are using the local UI, the screen will be blank while the switch reboots. If you are
using the remote OBWI, a message will appear to let you know that the interface is
waiting on the appliance to complete the reboot.
Upgrading the switch firmware
You can update your switch with the latest firmware available.
After the Flash memory is reprogrammed with the upgrade, the switch performs a
soft reset, which terminates all adapter cable sessions. A target device
experiencing an adapter cable firmware update may not display, or may display
as disconnected. The target device will appear normally when the Flash update
is completed.
WARNING: Disconnecting an adapter cable during a firmware update or cycling power
to the target device will render the module inoperable and require the adapter cable to
be returned to the factory for repair.
To upgrade the switch firmware:
1. From the side navigation bar, select Unit View > Appliance > Overview to
open the Unit Overview window.
2. Click Upgrade Firmware to open the Upgrade Appliance Firmware.
3. Select one of the following options from which to load the firmware file: File
System, TFTP, FTP, or HTTP.
The File System option is only available on the remote OBWI.
590-1058-640A
3.4 KVM s4 Switch Tools
27