Connecting The Switch Hardware - Fujitsu Control 4 Serie Guia Del Usuario

For complete instructions on installing the rack mounting bracket, please refer to
your KVM s4 Quick Installation Guide.
2.3

Connecting the switch hardware

To connect and turn on your switch:
To avoid potential video and/or keyboard problems when using Fujitsu
products: If the building has 3-phase AC power, ensure that the computer and
monitor are on the same phase. For best results, they should be on the same circuit.
WARNING: To reduce the risk of electric shock or damage to your
equipment:
- Do not disable the power grounding plug. The grounding plug is an important safety
feature.
- Connect the power cord into a grounded (earthed) outlet that is easily accessible at all
times.
- Disconnect the power from the product by unplugging the power cord from either the
electrical outlet or the product.
- The AC inlet is the main disconnect for removing power to this product. For products
that have more than one AC inlet, to remove power completely, all AC line cords must
be disconnected.
- This product has no user serviceable parts inside the product enclosure. Do not open
or remove product cover.
1. Connect your VGA monitor and USB keyboard and mouse cables into the
appropriately labeled ports.
2. Choose an available port on the switch. Connect one end of a UTP cable (4-
pair, up to 150 ft/45 m) into a numbered port. Connect the other end into an
RJ-45 connector of an adapter cable.
3. Connect the adapter cable into the appropriate ports on the back of a target
device. Repeat this procedure for all target devices you want to connect.
When connecting to a Sun Microsystems target device, you must use a multi-sync
monitor in the local port to accommodate Sun computers that support both VGA and
sync-on-green or composite sync.
4. Connect both LAN ports to independent Ethernet switches to provide
redundancy.
5. Turn on each target device, then locate the power cord(s) that came with the
switch. Connect one end into the power socket on the rear of the switch.
590-1058-640A
2.3 Connecting the switch hardware
11