LU-VE Emeritus LU1W Manual De Usuario página 129

To change the parameters in the wizard, use the UP and DOWN keys to move the cursor (black band) to the various
parameters. Upon reaching said parameters, press the ENTER key: the parameter starts blinking. You can change the
parameter values by using the UP and DOWN pushbuttons; then press ENTER to save the new value.
To move to the next screens, move the cursor to OK (bottom right of the page), and press ENTER.
When the wizard is finished, the procedure complete window appears.
If you want to perform the procedure later, press the ESC key and the home page will
appear. It will appear in any event at the end of the wizard. The home page appears
directly when powering up if the wizard has already been completed successfully.
Once you see the main screen, the unit is in standby mode, and UNIT OFF appears at
the centre of the screen. To start the adjustment, press and hold ESC for 3 sec.; the
controller status then becomes UNIT ON. If the unit remains in standby mode, see
section 3.3 Controller status and adjustment activation for other controller activation
modes.
LU1W - User Manual 6 REV.1.1 – 07/11/2017 - ENG