Porsche Home Energy Manager 9Y0.915.686 Manual De Instrucciones página 64

Starting Initial Installation
Displaying house connection phases as current
consumers
Instead of listing current consumers here, you can
also add the individual phases of the house connec-
tion. This allows phase-specific consumption to be
displayed in the Overview.
Configure the following settings:
1. Select Add current consumer.
2. Enter a name for the fictitious current consumer
(e.g. L1, L2 or L3).
3. Select Single phase as mains phase.
4. Assign the current converter that measures this
phase to the house connection.
Adding an EEBus device
b EEBus devices (e.g. charger Porsche Mobile
Charger Connect, Porsche Mobile Charger Plus)
and energy manager are located in the same
network.
b The EEBus device is switched on and not in
standby mode.
1. Select Add EEBus device.
�� Available EEBus devices are displayed. Only
devices that are not already connected to
the energy manager are displayed.
2. Select and configure:
You can identify the EEBus device by its ID num-
ber (SKI). The SKI of the charger Porsche Mobile
Charger Connect can be found in Web Applica-
tion of the charger (Connections e Energy man-
ager).
62
Information
Deactivate the standby mode of the charger Porsche
Mobile Charger Connect in the Web Application of
the charger.
Optional Explanation
Name Name of current consumer
Type Set by default as an EEBus device
Mains pha- Number of phases in the EEBus
ses device supply cable
Assign cur- Select the current converter that
rent sensor is connected to the EEBus device
to a phase. cable
e
Start connection on the charger.
–
charger Porsche Mobile Charger Connect:
Start EEBus connection in the Web Applica-
tion of the charger (Connections e Energy
manager) or on the charger (Settings e En-
ergy manager).
– Charger Porsche Mobile Charger Plus: Ac-
tivate the charge status Energy manager
on the device. The charger automatically at-
tempts to establish a connection to the PLC
network and to the energy manager.
e
Information on adding the energy manager in the
Web Application of the charger can be found in
the Installation Manual on the Porsche website
at the following address:
https://tinyurl.com/porsche-e-help
Information
Look out for a possible phase shift in the socket to
which the charger is connected.
Example:
An EEBus device is to be connected to a phase-shif-
ted socket, which does not use phase 1 as usual, but
uses phase 2 or is multi-phase, and which does not
begin with phase 1, but with phase 2.
The current converter that is assigned to phase 2 is
selected as the first current converter of a phase.
The current converter is now assigned to the EEBus
device cable.
Note: The Optimised charging function cannot be
used without mutual EEBus pairing with a charger
such as the Porsche Mobile Charger Connect. You
can tell that pairing was successful by the Energy
manager connected symbol (house icon) in the sta-
tus bar of the charger.
Information
Phase-individual reduction
Porsche vehicles supplied with an energy manager
can carry out a phase-specific reduction in the charg-
ing current. The chargers should therefore always be
configured for the correct phase, otherwise charging
will be restricted to the wrong phase.